Oakworks 300 Series Procedure Chair Rev.D User Manual download pdf (Page 10)

DIRECTIONS FOR USE

The chair can be easily rotated without a patient in it. This is the preferred method. To rotate the chair with an

average size patient, lower the backrest to about 45° to allow easier rotation.

To rotate the chair, locate the black push buttons at the top of the back rest section. Press in and hold either

one of the buttons to disengage the base locking mechanism. While holding in the push button, rotate the chair

to the desired position up to 240°.

CAUTION

SWIVEL BASE USE

When rotating the chair, make sure there is nothing around the chair that can impede

the rotational motion (like stools, cabinets, etc)

Rotate up

to 240º

1. Fully lower the powered

foot rest to allow access to

the stirrup.

3. Fold out to fully open posi-

tion.

2. Grasp Stirrup handle &

pull out firmly while lifting

slightly. Pull fully out.

4. To rotate stirrup to the

desired angle, lift slightly

and move to the desired

position. There are (3)

detent positions. Stop lift-

ing and move slightly left

or right for the nearest

detent position.

5. To reduce stirrup length,

lift the handle slightly and

push into desired position.

Stirrup will automatically

lock into nearest detent

position.

To store stirrups, lift slightly, rotate towards the middle of the chair and fold

the foot rest down. Then lift slightly and push into the storage position.

RETRACTABLE FOOT RESTS (STIRRUP) USE

CAUTION

Pinch Point - Keep fingers away from pinch point.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

No comments

Oakworks 300 Series Procedure Chair Rev.D User Manual Page 10